Controller configurator
Choose a face, color the enclosure, print the whole controller.
Preparing your controller…
100 mm dome-button preview. Button colors are hardware, not printed filaments.
PLAN YOUR PRINTS
Print plates
A shared filament list across the controller.
Up to four loaded colors on each plate.
What’s included, and what still needs setting?
Nine top panels, nine removable bottom panels and both sets of seven braces. Screws, heat-set inserts, magnets, buttons and electronics are purchased separately. Artwork prints face down for four layers at 0.20 mm; above that, only the structural filament remains. These are unsliced models with a 256 mm plate layout, not printer-ready G-code. Select your printer and filament profiles, check supports and solid infill around inserts, and inspect the sliced preview before printing.
Colors linked to the same swatch share a filament assignment. If a plate needs five colors, change its structural color to an existing swatch or merge two artwork swatches. More than four colors across different plates is supported; remap and reload CANVAS between jobs.
Geometry is digitally checked; physical fit and multicolor adhesion still need a test print. Artwork credits · Assembly guide